Modeling and ideal design for γ titanium aluminide alloy wire electrical discharge machining

Authors

  • Mamze ÖZAKINC Author

Keywords:

γ titanium aluminide, modeling, optimization, wire EDM

Abstract

The present study focuses on γ titanium aluminide wire electrical discharge machining (WEDM). It is 
challenging to choose the optimal machining parameter combinations for improved cutting efficiency and 
accuracy in WEDM because of the many process variables and complex stochastic process processes. 
Generally speaking, there isn't a single ideal combination that will provide both the best surface finish 
quality and the quickest cutting speed. The information was chosen for this purpose from a review of the 
literature. The endeavor to develop an appropriate machining method for attaining the maximum process 
criterion yield is described in this research. Differential evolution, a stochastic optimization technique, has 
been used to describe the machining process. The three most significant factors that have been used as 
process performance indicators are cutting speed, surface roughness, and wire offset. Six distinct control 
parameters—pulse on time, pulse off time, peak current, wire tension, dielectric flow rate, and servo 
reference voltage—can be used to forecast the response characteristics. After calculating the R2, R2, and 
R2 values to see if the model is realistic, the potential models' constraints are examined. For the maximum 
cutting speed, minimal surface roughness, and minimum wire offset, the optimization values are 3.02 
mm/min, 2.36 µm, and 0.13 mm, respectively. It is shown that the optimization method satisfies real-world 
needs and that the machining model is appropriate. 

Downloads

Published

2026-06-29